Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20133 MAZDASPEED, 2.3L ENG VIN 3REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 35 (MANUAL TRANSAXLE (SERVICE, REMOVAL & INSTALLATION G66M-R))NEUTRAL SWITCH REMOVAL/INSTALLATION
2013 Mazda 3 Mazdaspeed, 2.3L Eng VIN 3
Neutral Switch Removal/Installation
2013 Mazda 3 Mazdaspeed, 2.3L Eng VIN 3SECTION Neutral Switch Removal/Installation
WARNING: This page is about a different variant/trim than selected.
- Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [MZR 2.0, MZR 2.5] .)
- Disconnect the negative battery cable.
- Remove the battery component. (ex: battery, battery tray and PCM component) (See BATTERY REMOVAL/INSTALLATION [MZR 2.0, MZR 2.5] .)
- Remove the aerodynamic under cover No.2. (See AERODYNAMIC UNDER COVER NO.2 REMOVAL/INSTALLATION .)
- Drain the oil from the transaxle. (See TRANSAXLE OIL REPLACEMENT .)
- Remove the neutral switch.
- Install the neutral switch (with a new gasket) to the transaxle case.
Tightening torque
- 20-29 N.m {2.1-2.9 kgf.m, 15-21 ft.lbf}
- Install the battery component. (ex: battery, battery tray and PCM component) (See BATTERY REMOVAL/INSTALLATION [MZR 2.0, MZR 2.5] .)
- Install the battery cover. (See BATTERY REMOVAL/INSTALLATION [MZR 2.0, MZR 2.5] .)
- Add the specified amount and type of oil. (See TRANSAXLE OIL REPLACEMENT .)
- Install the aerodynamic under cover No.2. (See AERODYNAMIC UNDER COVER NO.2 REMOVAL/INSTALLATION .)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.