Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20133 MAZDASPEED, 2.3L ENG VIN 3REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 33 (MANUAL TRANSAXLE CLUTCH [G66M-R])CLUTCH RELEASE CYLINDER REMOVAL/INSTALLATIONNOTES
2013 Mazda 3 Mazdaspeed, 2.3L Eng VIN 3
Clutch Release Cylinder Removal/Installation: Notes
2013 Mazda 3 Mazdaspeed, 2.3L Eng VIN 3SECTION Notes
WARNING: This page is about a different variant/trim than selected.
CAUTION:
- Fluid will damage painted surfaces. Be careful not to spill any on painted surfaces. If it is spilled, wipe it off immediately.
- Remove the aerodynamic under cover No.2. (See AERODYNAMIC UNDER COVER NO.2 REMOVAL/INSTALLATION .)
- Remove in the order indicated in the table.
- Install in the reverse order of removal.
- Bleed the air from the system. (See CLUTCH FLUID AIR BLEEDING/REPLACEMENT .)
- After installation, inspect the clutch pedal. (See CLUTCH PEDAL INSPECTION/ADJUSTMENT .)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.