Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20133 MAZDASPEED, 2.3L ENG VIN 3REPAIR AND DIAGNOSISBODY & FRAMEWINDOWSGLASS/WINDOWS/MIRRORSREAR WINDOW GLASS REMOVAL5HB
2013 Mazda 3 Mazdaspeed, 2.3L Eng VIN 3
Rear Window Glass Removal: 5HB
2013 Mazda 3 Mazdaspeed, 2.3L Eng VIN 3SECTION 5HB
- Disconnect the negative battery cable.
- Remove the following parts:
- Liftgate upper trim (See LIFTGATE UPPER TRIM REMOVAL/INSTALLATION .)
- High-mount brake light (See HIGH-MOUNT BRAKE LIGHT REMOVAL/INSTALLATION .)
- Liftgate side trim (See LIFTGATE SIDE TRIM REMOVAL/INSTALLATION .)
- Liftgate lower trim (See LIFTGATE LOWER TRIM REMOVAL/INSTALLATION .)
- Rear spoiler (See REAR SPOILER REMOVAL/INSTALLATION .)
- Rear wiper arm and blade (See REAR WIPER ARM AND BLADE REMOVAL/INSTALLATION .)
- Disconnect the filament connector.
- Apply protective tape along the edge of the body.
-
NOTE: Overlap and adhere the protective tape to the corners to prevent damage.
-
- Avoiding the pin on the inside of the vehicle, insert piano wire which has been cut to sufficient length.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.