SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20133 MAZDASPEED, 2.3L ENG VIN 3REPAIR AND DIAGNOSISBODY & FRAMEWINDOWSGLASS/WINDOWS/MIRRORSFRONT DOOR GLASS REMOVAL/INSTALLATION
2013 Mazda 3 Mazdaspeed, 2.3L Eng VIN 3

Front Door Glass Removal/Installation

2013 Mazda 3 Mazdaspeed, 2.3L Eng VIN 3SECTION Front Door Glass Removal/Installation
  1. To access the glass installation bolt, position the front door glass so that the distance from the top of the front door glass to the upper part of the front beltline molding is approx. 80 mm {3.1 in}  .
    Fig 1: Identifying Front Door Glass Distance
    G08158557
  2. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [MZR 2.0, MZR 2.5] .) (See BATTERY REMOVAL/INSTALLATION [MZR 2.3 DISI TURBO] .) (See BATTERY REMOVAL/INSTALLATION [SKYACTIV-G 2.0] .)
  3. Remove the inner garnish. (See INNER GARNISH REMOVAL/INSTALLATION .)
  4. Remove the front door trim. (See FRONT DOOR TRIM REMOVAL/INSTALLATION .)
  5. Remove the front door speaker. (See FRONT DOOR SPEAKER REMOVAL/INSTALLATION .)
  6. Remove the hole plug.
    Fig 2: Front Door And Hole Plug
    G08158558
  7. Remove the bolts.
    Fig 3: Front Door Bolts With Torque Specification
    G08158559
      CAUTION: If the bolts are removed without supporting the front door glass, the front door glass may fall off and be damaged. Remove the bolts while inserting your hand into the front door speaker installation hole to support the front door glass.
  8. Lift up the front door glass, tilt it in the direction of arrow (1) shown in the figure, then remove it in the direction of arrow (2).
    Fig 4: Lifting Up Front Door Glass (1 Of 2)
    G08158560
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.