Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSMAZDA20133 MAZDASPEED, 2.3L ENG VIN 3REPAIR AND DIAGNOSISBODY & FRAMESEATSSEAT SYSTEMFRONT SEAT BACK TRIM REMOVAL/INSTALLATIONINSTALLATION

2013 Mazda 3 Mazdaspeed, 2.3L Eng VIN 3

Front Seat Back Trim Removal/Installation: Installation

2013 Mazda 3 Mazdaspeed, 2.3L Eng VIN 3SECTION Installation

Install the seat back trim to the front seat back pad, install the rings C in the order of (1), (2), (3) shown in the figure, then install the seat back trim.

Fig 1: Installing Seat Back Trim
Install the seat back trim and the seat back pad as a single unit from the seat frame by pushing them in the direction of the arrow

Fig 2: Installing Seat Back Trim And Seat Back Pad
Pass holder bracket A through slit A, holder hook B through slit B of the seat back pad.

Fig 3: Passing Holder Bracket A

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.