Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20133 MAZDASPEED, 2.3L ENG VIN 3REPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTSTEERING COLUMN SWITCHESLIGHTING SYSTEMHEADLIGHT AUTO LEVELING SYSTEM INITIALIZATIONUSING M-MDS
2013 Mazda 3 Mazdaspeed, 2.3L Eng VIN 3
Using M-MDS
2013 Mazda 3 Mazdaspeed, 2.3L Eng VIN 3SECTION Using M-MDS
- Connect the M-MDS to the DLC-2.
- After the vehicle is identified, select the following items from the initial screen of the M-MDS.
- When using the IDS (laptop PC)
- Select "Electrical".
- Select "Exterior Lighting".
- Select "Headlamp".
- Select "Auto Leveling Sensor Re-zero Procedure"
- When using the IDS (laptop PC)
- Adjust the headlight aiming. (See HEADLIGHT AIMING .)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.