SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20133 MAZDASPEED, 2.3L ENG VIN 3REPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALGAUGESINSTRUMENTATION/DRIVER INFOBLIND SPOT MONITORING (BSM) BRACKET REMOVAL/INSTALLATION
2013 Mazda 3 Mazdaspeed, 2.3L Eng VIN 3

Blind Spot Monitoring (BSM) Bracket Removal/Installation

2013 Mazda 3 Mazdaspeed, 2.3L Eng VIN 3SECTION Blind Spot Monitoring (BSM) Bracket Removal/Installation
  1. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [MZR 2.0, MZR 2.5] .)(See BATTERY REMOVAL/INSTALLATION [MZR 2.3 DISI TURBO] .)(See BATTERY REMOVAL/INSTALLATION [SKYACTIV-G 2.0] .)
  2. Remove the rear combination light. (See REAR COMBINATION LIGHT REMOVAL/INSTALLATION .)
  3. Remove the rear bumper. (See REAR BUMPER REMOVAL/INSTALLATION .)
  4. Remove the BSM control module. (See BLIND SPOT MONITORING (BSM) CONTROL MODULE REMOVAL/INSTALLATION .)
  5. Remove the nuts.
    Fig 1: BSM Bracket Nuts With Torque Specification
    G08159616
  6. Remove the clip.
    Fig 2: BSM Bracket Clips
    G08159617
  7. Remove the BSM bracket.
  8. Install in the reverse order of removal.
  9. Perform the blind spot monitoring radar test. (See BLIND SPOT MONITORING (BSM) RADAR TEST .)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.