Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20133 MAZDASPEED, 2.3L ENG VIN 3REPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESTRACTION CONTROLDYNAMIC STABILITY CONTROL SYSTEMDYNAMIC STABILITY CONTROL OFF SWITCH INSPECTION
2013 Mazda 3 Mazdaspeed, 2.3L Eng VIN 3
Dynamic Stability Control Off Switch Inspection
2013 Mazda 3 Mazdaspeed, 2.3L Eng VIN 3SECTION Dynamic Stability Control Off Switch Inspection
- Remove the DSC OFF switch. (See DSC OFF SWITCH REMOVAL/INSTALLATION .)
- Verify that the continuity between the DSC OFF switch terminals is as indicated in the table.
- If not as indicated in the table, replace the DSC OFF switch.
- Apply battery voltage to DSC OFF switch terminal E, and connect terminal A to ground.
- Verify that the LED illuminates.
- If there is any malfunction, replace the DSC OFF switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.