Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20133 MAZDASPEED, 2.3L ENG VIN 3REPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESANTI-LOCK BRAKESON-BOARD DIAGNOSTIC [DYNAMIC STABILITY CONTROL SYSTEM]ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL (DSC)]CLEARING DTCS PROCEDURE
2013 Mazda 3 Mazdaspeed, 2.3L Eng VIN 3
Clearing DTCs Procedure
2013 Mazda 3 Mazdaspeed, 2.3L Eng VIN 3SECTION Clearing DTCs Procedure
- Connect the M-MDS (IDS) to the DLC-2.
- After the vehicle is identified, select the following items from the initialization screen of the IDS.
- Select "Self Test".
- Select "Modules".
- Select "ABS".
- Verify the DTC according to the directions on the screen.
- Press the clear button on the DTC screen to clear the DTC.
- Switch the ignition to off.
- Switch the ignition to ON and wait for 5 s or more .
- Perform DTC inspection. (See READING DTCS PROCEDURE .)
- Verify that no DTCs are displayed.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.