Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20133 MAZDASPEED, 2.3L ENG VIN 3REPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTHEATED GLASS/DEFOGGERSGLASS/WINDOWS/MIRRORSREAR WINDOW GLASS INSTALLATION5HB
2013 Mazda 3 Mazdaspeed, 2.3L Eng VIN 3
Rear Window Glass Installation: 5HB
2013 Mazda 3 Mazdaspeed, 2.3L Eng VIN 3SECTION 5HB
- Remove sealant along the perimeter of the glass using a utility knife or scraper. (When reusing the glass)
- Clean and degrease an approx. 50 mm {2.0 in} wide strip along the perimeter of the glass.
- Inspect the glass for cracks. If it is cracked, chamfer it using sandpaper.
- Install the spacers, and pins to the glass as shown in the figure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.