DTC Inspection Note

2013 Mazda 3 Mazdaspeed, 2.3L Eng VIN 3SECTION DTC Inspection Note
  • There are two methods of DTC inspection for the audio system: The on-board diagnostic test mode by operating the audio unit to activate the on-board diagnostic function, and using the M-MDS. (See DTC INSPECTION [AUDIO] .)
CAUTION:
  • Because there are DTCs which are not available in the on-board diagnostic test mode, the displayed DTC may differ depending on whether the on-board diagnostic test mode or the M-MDS is used. If there is a malfunction in the audio system even though a DTC is not displayed in the on-board diagnostic test mode, perform the DTC inspection using the M-MDS. (See DTC TABLE [AUDIO] .)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.