Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20133 MAZDASPEED, 2.3L ENG VIN 3REPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOLLISION/AVOIDANCEINSTRUMENTATION/DRIVER INFOBLIND SPOT MONITORING (BSM) OFF SWITCH REMOVAL/INSTALLATION
2013 Mazda 3 Mazdaspeed, 2.3L Eng VIN 3
Blind Spot Monitoring (BSM) Off Switch Removal/Installation
2013 Mazda 3 Mazdaspeed, 2.3L Eng VIN 3SECTION Blind Spot Monitoring (BSM) Off Switch Removal/Installation
- Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [MZR 2.0, MZR 2.5] .)(See BATTERY REMOVAL/INSTALLATION [MZR 2.3 DISI TURBO] .)(See BATTERY REMOVAL/INSTALLATION [SKYACTIV-G 2.0] .)
- Remove the switch panel in the direction of the arrow shown in the figure.
- Disconnect the connector.
- Remove the BSM OFF switch in the direction of the arrow (2) shown in the figure while pressing the tabs in the direction of the arrow (1).
- Remove the BSM OFF switch.
- Install in the reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.