Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSMAZDA20132 TOURING, 1.5L ENG VIN Z, AUTOMATIC TRANSREPAIR AND DIAGNOSISBRAKESANTI-LOCK BRAKESDYNAMIC STABILITY CONTROL SYSTEMFRONT ABS WHEEL-SPEED SENSOR REMOVAL/INSTALLATIONNOTES

2013 Mazda 2 Touring, 1.5L Eng VIN Z, Automatic Trans

Front Abs Wheel-Speed Sensor Removal/Installation: Notes

2013 Mazda 2 Touring, 1.5L Eng VIN Z, Automatic TransSECTION Notes

Remove in the order indicated in the table.
Install in the reverse order of removal.
After installation, verify that there is no twisting in the ABS wheel-speed sensor.

Fig 1: Front ABS Wheel-Speed Sensor, Connector And Clip With Torque Specifications

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.