SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20132 TOURING, 1.5L ENG VIN Z, AUTOMATIC TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMON-BOARD DIAGNOSTIC [ENGINE CONTROL SYSTEM MZR 1.5]DTC P0602:00: PCM PROGRAMMING ERRORNOTES
2013 Mazda 2 Touring, 1.5L Eng VIN Z, Automatic Trans

DTC P0602:00: PCM programming error: Notes

2013 Mazda 2 Touring, 1.5L Eng VIN Z, Automatic TransSECTION Notes
DTC DETECTION CONDITION & POSSIBLE CAUSES

DTC P0602:00  PCM programming error 
DETECTION CONDITION 
  • No configuration data in the PCM.
    NOTE:
    • If the "PCM CONFIGURATION" is successful, the PCM stores the DTC P0602:00 and illuminates the MIL (the system is normal). Clear the DTC P0602:00 using the M-MDS after the "PCM CONFIGURATION".
    • The MIL turns off after three drive cycles with no failure (the DTCs remain in PCM).

Diagnostic support note 
  • This is a continuous monitor (CCM).
  • The MIL illuminates if the PCM detects the above malfunction condition during the first drive cycle.
  • FREEZE FRAME DATA (Mode 2)/Snapshot data is available.
  • The DTC is stored in the PCM memory.
POSSIBLE CAUSE 
  • Configuration procedure has not been completed
  • PCM malfunction
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.