Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20132 TOURING, 1.5L ENG VIN Z, AUTOMATIC TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE MECHANICALACCESSORY DRIVE BELTSENGINE MECHANICAL (SERVICE, REMOVAL AND INSTALLATION MZR 1.5)TIMING CHAIN REMOVAL/INSTALLATIONNO.3 ENGINE MOUNT REMOVAL NOTE
2013 Mazda 2 Touring, 1.5L Eng VIN Z, Automatic Trans
No.3 Engine Mount Removal Note
2013 Mazda 2 Touring, 1.5L Eng VIN Z, Automatic TransSECTION No.3 Engine Mount Removal Note
CAUTION:
- Do not loosen the bolt shown in the figure because it cannot be installed properly if loosened once.
- When supporting the clutch housing, verify that any switches and wiring harnesses are not caught (MTX).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.