Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20132 TOURING, 1.5L ENG VIN Z, AUTOMATIC TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEWINDOWSGLASS/WINDOWS/MIRRORSPOWER WINDOW MAIN SWITCH INSPECTIONNOTES
2013 Mazda 2 Touring, 1.5L Eng VIN Z, Automatic Trans
Power Window Main Switch Inspection: Notes
2013 Mazda 2 Touring, 1.5L Eng VIN Z, Automatic TransSECTION Notes
- Switch the ignition to ON.
- Verify that the door glass (driver's side) can be operated for approx. 43 s
after the ignition switched to off.
- If the door glass (driver's side) cannot be operated for approx. 43 s after the after the ignition switched to off, of if the door glass (driver's side) can still be operated after approx. 43 s, replace the power window main switch.
- Disconnect the negative battery cable.
- Remove the inner garnish. (See INNER GARNISH REMOVAL/INSTALLATION ).
- Remove the front door trim. (See FRONT DOOR TRIM REMOVAL/INSTALLATION ).
- Remove the switch panel. (See FRONT DOOR TRIM DISASSEMBLY/ASSEMBLY ).
- Connect the power window main switch connector.
- Connect the negative battery cable.
- Measure the voltage at each terminal.
- If the voltage is not as specified in the terminal voltage table, inspect the parts under Inspection item(s) and related wiring harnesses.
- If the system does not work normally even though the inspection items or related wiring harnesses do not have any malfunction, replace the power window main switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.