Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20132 TOURING, 1.5L ENG VIN Z, AUTOMATIC TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTEXTERIOR LIGHTSLIGHTING SYSTEMHEADLIGHT BULB REMOVAL/INSTALLATION
2013 Mazda 2 Touring, 1.5L Eng VIN Z, Automatic Trans
Headlight Bulb Removal/Installation
2013 Mazda 2 Touring, 1.5L Eng VIN Z, Automatic TransSECTION Headlight Bulb Removal/Installation
- Disconnect the negative battery cable.
- Remove the fasteners and slightly bend back the mudguard. (LH only)
- Disconnect the connector.
- Remove the rubber cover.
- Press the bulb retaining wire in the direction of the arrow to release the lock.
- Remove the headlight bulb.CAUTION:
- A bulb generates extremely high heat when it is illuminated. If the surface of the bulb is soiled, heat of higher temperature than normal will build, shortening the life of the bulb. When replacing the bulb, hold the metal flange, not the glass.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.