Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20132 SPORT, 1.5L ENG VIN Y, STANDARD TRANSREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLDYNAMIC STABILITY CONTROL SYSTEMFRONT ABS WHEEL-SPEED SENSOR REMOVAL/INSTALLATIONCLIP REMOVAL NOTE
2013 Mazda 2 Sport, 1.5L Eng VIN Y, Standard Trans
Clip Removal Note
2013 Mazda 2 Sport, 1.5L Eng VIN Y, Standard TransSECTION Clip Removal Note
NOTE:
- Do not remove the clip except when replacing it.
- Cut the band area of the clip, then remove the clip from the ABS wheel-speed sensor.CAUTION:
- Be careful not to damage the ABS wheel-speed sensor when cutting the band area of the clip.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.