Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20126 V6-3.7LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTFUEL DELIVERY AND AIR INDUCTIONSERVICE PRECAUTIONSBEFORE SERVICE PRECAUTION
2012 Mazda 6 V6-3.7L
Before Service Precaution
2012 Mazda 6 V6-3.7LSECTION Before Service Precaution
BEFORE SERVICE PRECAUTION [MZI 3.7 V6]
WARNING:
- Fuel vapor is hazardous. It can easily ignite, causing serious injury and damage. Always keep sparks and flames away from fuel.
- Fuel line spills and leakage are dangerous. Fuel can ignite and cause serious injuries or death and damage. Fuel can also irritate skin and eyes. To prevent this, always complete the following "Fuel Line Safety Procedure".
- A person charged with static electricity could cause a fire or explosion, resulting in death or serious injury. Before performing work on the fuel system, discharge static electricity by touching the vehicle body.
Fuel Line Safety Procedure
1. Disconnect the negative battery cable. Removal and Replacement
2. Remove the fuel-filler cap to release the pressure inside the fuel tank.
3. Disconnect the fuel pump unit connector. Removal and Replacement
4. Connect the negative battery cable. Removal and Replacement
5. Start the engine.
6. After the engine stalls, crank the engine 2-3times.
7. Switch the ignition to off.
8. Connect the fuel pump unit connector.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.