Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20126 V6-3.7LREPAIR AND DIAGNOSISLIGHTING AND HORNSLICENSE PLATE LAMPSERVICE AND REPAIR
2012 Mazda 6 V6-3.7L
License Plate Lamp: Service and Repair
2012 Mazda 6 V6-3.7LSECTION Service and Repair
LICENSE PLATE LIGHT REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the following parts:
a. Recess Recess Removal/Installation
b. Trunk rid trim
c. Rear finisher
d. License plate light bulb Service and Repair
3. Press tab A in the direction of the arrow (1) shown in the figure, press the license plate light in the direction of the arrow (2), and detach tab B.
4. Remove the license plate light.
5. Install in the reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.