Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20126 V6-3.7LREPAIR AND DIAGNOSISBODY AND FRAMEMIRRORSSERVICE AND REPAIRPOWER OUTER MIRROR REMOVAL/INSTALLATION
2012 Mazda 6 V6-3.7L
Power Outer Mirror Removal/Installation
2012 Mazda 6 V6-3.7LSECTION Power Outer Mirror Removal/Installation
POWER OUTER MIRROR REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the inner garnish. Inner Garnish Removal/Installation
3. Remove the front door trim. Front Door Trim Removal/Installation
4. Disconnect the power outer mirror connector.
5. Remove the bolts.
6. Push the power outer mirror against the vehicle and detach the tab while lifting the mirror up to remove.
7. Install in the reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.