Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2011TRIBUTE HYBRID TOURING, FWDLABOR TIMESOTHER VARIANTDRIVELINES AND AXLESDIFFERENTIALS AND DRIVE AXLES - REARAXLE SHAFTREMOVE & REPLACE
2011 Mazda Tribute Hybrid Touring, FWD
Axle Shaft: Remove & Replace
2011 Mazda Tribute Hybrid Touring, FWDSECTION Remove & Replace
WARNING: This page is about the Tribute Hybrid Grand Touring, AWD, which is a different variant/trim than selected.
NOTE: For Independent Suspension Type Axles, this operation consists of removal and installation, dissassembly and reassembly of the Axle Shaft Assembly and replacement of the Axle Shaft.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| AWD, Halfshaft,Both | 3.8 | B | ||
| AWD, Halfshaft,One Side | 2.5 | B | ||
| Combination Procedure: CONSTANT VELOCITY JOINT: Remove & Replace: | ||||
| Both Sides,All Four | 1.1 | B | ||
| One Side,Both | 0.6 | B | ||
| One Side,One | 0.4 | B | ||
| Combination Procedure: DIFFERENTIAL OUTPUT SEAL: Remove & Replace: | ||||
| Each | 0.3 | B | ||
| Combination Procedure: DIFFERENTIAL PINION SEAL: Remove & Replace: | ||||
| 0.3 | B | |||
| Combination Procedure: WHEEL BEARING: Remove & Replace: | ||||
| Each | 0.5 | B | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.