Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Determine Open Circuit Location (Ms-Can) [Multiplex Communication System]: Notes
2011 Mazda RX-8 Sport, 1.3 2SECTION Notes
CAUTION:
- If the malfunctioning part is detected in the communication line, before disconnecting the related connector for inspection, press the connector in the connection direction to verify that there is no looseness or disconnection.
- When disconnecting the connector, verify that there is no damage, deformation, or corrosion of the connector terminals.
- Verify DTCs of the modules related to the CAN system.
- Apply the following items to the DTC output pattern and the malfunctioning location, and then verify the reference to the malfunctioning location.
- Communication error DTCs
- Display status of the air conditioner/audio control on the information display when the climate control unit/either of the audio unit or the car-navigation unit is operated.
- The operation condition of the SIRIUS satellite radio system and the hands-free telephone system.
NOTE:- A hyphen (-) in the DTC output pattern cell indicates that the DTC may or may not be displayed depending on the malfunction detection conditions. If it is not displayed, the malfunctioning location can be determined by checking the crosses (x) and asterisks (*.)
- Inspect the possible cause and inspection item of the applicable malfunctioning part.
- Perform the DTC inspection after the repair procedure.
- If any DTC is displayed, return to FOREWORD [MULTIPLEX COMMUNICATION SYSTEM] .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.