Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2011CX-7 I SPORT, 2.5 5REPAIR AND DIAGNOSISBRAKESTRACTION CONTROLDYNAMIC STABILITY CONTROL SYSTEMFRONT ABS WHEEL-SPEED SENSOR INSPECTIONCLEARANCE INSPECTION
2011 Mazda CX-7 i Sport, 2.5 5
Clearance Inspection
2011 Mazda CX-7 i Sport, 2.5 5SECTION Clearance Inspection
- Verify the clearance between the front ABS sensor rotor and the front ABS wheel-speed sensor.
- If there is any malfunction, check for improper installation, and replace if necessary.
Clearance
- 0.7-1.5 mm {0.028-0.059 in}
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.