Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2011CX-7 I SV, 2.5 5REPAIR AND DIAGNOSISENGINE PERFORMANCEENGINE CONTROL SYSTEMSENGINE CONTROL SYSTEM [L5]MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR INSPECTION
2011 Mazda CX-7 i SV, 2.5 5
Manifold Absolute Pressure (Map) Sensor Inspection
2011 Mazda CX-7 i SV, 2.5 5SECTION Manifold Absolute Pressure (Map) Sensor Inspection
- Connect the M-MDS to the DLC-2.
- Turn the ignition switch to the ON position.
- Verify that the voltage (M-MDS PID: MAP) within the specification. (See
PCM INSPECTION .)
- If not as specified, replace the MAP sensor. (See MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR REMOVAL/INSTALLATION .)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.