Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSMAZDA2011CX-7 I SV, 2.5 5REPAIR AND DIAGNOSISBODY & FRAMEWINDOWSSYMPTOM TROUBLESHOOTING [POWER WINDOW SYSTEMS - AUTO-OPEN/CLOSE FUNCTION)BASIC POWER WINDOW SYSTEM INSPECTION [POWER WINDOW SYSTEMS (AUTO-OPEN/CLOSE FUNCTION)]MANUAL MODE FUNCTION INSPECTION

2011 Mazda CX-7 i SV, 2.5 5

Manual Mode Function Inspection

2011 Mazda CX-7 i SV, 2.5 5SECTION Manual Mode Function Inspection

MANUAL MODE FUNCTION INSPECTION CHART

STEP	INSPECTION		ACTION
1	Turn the ignition switch to the ON position. Turn the power-cut switch to UNLOCK. Does each door glass move up and down in manual mode using the power window subswitch?	Yes	Go to the next step.
1		No	Inspect the following items: Power window main switch (power-cut switch system malfunction) Power window subswitch power supply fuses Power window subswitch ground wiring harness Power window subswitch power supply wiring harnesses Wiring harness between power window subswitch and power window motor Power window subswitch Power window motor Repair or replace the malfunctioning part, then go to the next step.
2	Does the driver-side door glass move up and down in manual mode using the power window main switch?	Yes	Go to the next step.
2		No	Inspect the following items: Power window main switch power supply fuses Power window main switch ground wiring harness Power window main switch power supply wiring harnesses Wiring harness between power window main switch and power window motor Power window main switch Repair or replace the malfunctioning part, then go to the next step.
3	Does each other door glass other than the driver-side door glass move up and down in manual mode using the power window main switch?	Yes	Go to the next step.
3		No	Perform the power window initialization procedure for any door glass that does not move up and down, and reinspect. (See POWER WINDOW INITIALIZATION PROCEDURE .) If it does not move up and down upon reinspection, inspect the following: Wiring harness between power window main switch and subswitch Repair or replace the malfunctioning part, then go to the next step.
4	Turn the power-cut switch to LOCK. Push/pull the power window main switch (switches for all windows in manual mode). Does only driver-side front door glass move up and down?	Yes	Manual mode function is normal. Go to the AUTOMATIC MODE FUNCTION INSPECTION .
4		No	Replace the power window main switch, then go to the AUTOMATIC MODE FUNCTION INSPECTION (power-cut switch system malfunction).

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.