No. 8 Display Does Not Change To The Rear Mount Camera Image [Car-Navigation System (Integrated Multi Information Display)]: Notes

2011 Mazda CX-7 i SV, 2.5 5SECTION Notes
POSSIBLE CAUSE - NO. 8 DISPLAY DOES NOT CHANGE TO REAR MOUNT CAMERA IMAGE AND CAR-NAVIGATION SYSTEM (INTEGRATED MULTI INFORMATION DISPLAY)

8 Display does not change to the rear mount camera image
POSSIBLE CAUSEΒ 
  • Rear mount camera malfunction
  • Poor connection of the rear mount camera connector, terminal damage
  • Poor connection of the multi information display connector, terminal damage
  • Open or short circuit in wiring harness between multi information display and rear mount camera
  • Open or short circuit in reverse signal wiring harness
  • Multi information display malfunction
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.