Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSMAZDA2011CX-7 I SV, 2.5 5REPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINFOTAINMENTSYMPTOM TROUBLESHOOTING [NAVIGATION SYSTEM - INTEGRATED MULTI INFORMATION DISPLAY)NO. 1 CAR-NAVIGATION SYSTEM DOES NOT START OPERATION (DISPLAY CHANGES TO BACK.) [CAR-NAVIGATION SYSTEM (INTEGRATED MULTI INFORMATION DISPLAY)]NOTES

2011 Mazda CX-7 i SV, 2.5 5

No. 1 Car-Navigation System Does Not Start Operation (Display Changes To Back.) [Car-Navigation System (Integrated Multi Information Display)]: Notes

2011 Mazda CX-7 i SV, 2.5 5SECTION Notes

POSSIBLE CAUSE - NO. 1 CAR-NAVIGATION SYSTEM DOES NOT START OPERATION (DISPLAY CHANGES TO BACK)

Car-navigation system does not start operation (Display changes to black.)

POSSIBLE CAUSE

Fuse malfunction
Open or short circuit in multi information display (power supply (B+)) wiring harness
Open or short circuit in multi information display (power supply (ACC)) wiring harness
Open or short circuit in car-navigation unit (integrated multi information display) (GND) wiring harness
Open or short circuit in multi information display) (GND) wiring harness
Melted or damaged power supply (B+, ACC) related fuse
Car-navigation unit (integrated multi information display) malfunction
Poor connection of multi information display connector, terminal damage
NOTE:
- After inserting the SD card of Navigation Map data, firmly close all of the lids.
- If the inner lid is not firmly closed, the navigation system will not function.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.