Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2011CX-7 I SV, 2.5 5REPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESCONTROL SYSTEM (BODY CONTROL MODULE)BODY CONTROL MODULE (BCM) INSPECTIONNOTES
2011 Mazda CX-7 i SV, 2.5 5
Body Control Module (BCM) Inspection: Notes
2011 Mazda CX-7 i SV, 2.5 5SECTION Notes
- Disconnect the negative battery cable.
- Remove the following parts:
- Front scuff plate, (driver-side) (See FRONT SCUFF PLATE REMOVAL/INSTALLATION .)
- Front side trim, (driver-side) (See FRONT SIDE TRIM REMOVAL/INSTALLATION .)
- Console panel. (See CONSOLE PANEL REMOVAL/INSTALLATION .)
- Console (See CONSOLE REMOVAL/INSTALLATION .)
- Set the hood release lever out of the way. (See HOOD LATCH AND RELEASE LEVER REMOVAL/INSTALLATION .)
- Remove the lower panel. (See LOWER PANEL REMOVAL/INSTALLATION .)
- Remove the BCM with the connector connected. (See BODY CONTROL MODULE (BCM) REMOVAL/INSTALLATION .)
- Connect the negative battery cable.
- Measure the voltage at each terminal is as indicated in the Terminal Voltage Tables below.
- If the voltage is not as specified in the Terminal Voltage Table, inspect the parts under "Inspection item (s)".
- If the system does not work properly even though the parts or related wiring harnesses do not have any malfunction, replace the BCM.
- If the voltage is not as specified in the Terminal Voltage Table, inspect the parts under "Inspection item (s)".
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.