Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20113 MAZDASPEED, 2.3 3REPAIR AND DIAGNOSISTRANSMISSIONMANUAL TRANSMANUAL TRANSAXLE (SERVICE, REMOVAL & INSTALLATION A26M-R)NEUTRAL SWITCH REMOVAL/INSTALLATION
2011 Mazda 3 Mazdaspeed, 2.3 3
Neutral Switch Removal/Installation
2011 Mazda 3 Mazdaspeed, 2.3 3SECTION Neutral Switch Removal/Installation
- Disconnect the negative battery cable.
- Disconnect the neutral switch connector.
- Remove the aerodynamic undercover No. 2. (See AERODYNAMIC UNDER COVER NO. 2 REMOVAL/INSTALLATION ).
- Remove the neutral switch with the gasket.
- Install a new gasket and the neutral switch to the transaxle case.
Tightening torque
29-39 N.m {3.0-3.9 kgf.m, 22-28 ft.lbf}
- Install the aerodynamic under cover No. 2. (See AERODYNAMIC UNDER COVER NO. 2 REMOVAL/INSTALLATION ).
- Connect the neutral switch connector.
- Connect the negative battery cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.