Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20113 MAZDASPEED, 2.3 3REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 652 (SECURITY SYSTEM AND LOCKS SYSTEM)KEYLESS CONTROL MODULE REMOVAL/INSTALLATION
2011 Mazda 3 Mazdaspeed, 2.3 3
Keyless Control Module Removal/Installation
2011 Mazda 3 Mazdaspeed, 2.3 3SECTION Keyless Control Module Removal/Installation
WARNING: This page is about a different car, the 2011 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
- When replacing the keyless control module, perform the following procedure:
- Keyless Control Module Configuration (See KEYLESS CONTROL MODULE CONFIGURATION .)
- Immobilizer System-related Parts Programming [with advanced keyless system] (See IMMOBILIZER SYSTEM-RELATED PARTS PROGRAMMING [WITH ADVANCED KEYLESS SYSTEM] )
- Immobilizer system-related parts programming [with keyless entry system] (See IMMOBILIZER SYSTEM-RELATED PARTS PROGRAMMING [WITH KEYLESS ENTRY SYSTEM] .)
- Disconnect the negative battery cable.
- Remove the front side trim. (See FRONT SIDE TRIM REMOVAL/INSTALLATION .)
- Remove the nut and screw.
- Remove the connector clip installed to the bracket by shifting the keyless control module downward.
- Disconnect the keyless control module connector.
- Install in the reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.