Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSMAZDA20113 MAZDASPEED, 2.3 3REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 652 (SECURITY SYSTEM AND LOCKS SYSTEM)IMMOBILIZER SYSTEM-RELATED PARTS PROGRAMMING [WITH KEYLESS ENTRY SYSTEM]NO. 1 ADDITIONAL KEY PROGRAMMING PROCEDURE (USING TWO VALID KEYS)PROCEDURE

2011 Mazda 3 Mazdaspeed, 2.3 3

No. 1 Additional Key Programming Procedure (Using Two Valid Keys): Procedure

2011 Mazda 3 Mazdaspeed, 2.3 3SECTION Procedure

WARNING: This page is about a different car, the 2011 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Key Reference Chart (Using Two Valid Keys)

Courtesy of MAZDA MOTORS CORP.

KEY PROGRAMMING PROCEDURE

Step	Procedure	Action after procedure
1	LAUNCH PROGRAMMING MODE Turn the ignition switch to the ON position using key 1. After verifying that the security light illuminates for approx. 3 s and turns off, turn the ignition switch to the LOCK position within approx. 4 s using key 1. Remove key 1. Turn the ignition switch to the ON position using key 2. After verifying that the security light illuminates for approx. 3 s and turns off, turn the ignition switch to the LOCK position within approx. 4 s using key 2. Remove key 2.	Go to the next step.
2	PERFORM ADDITIONAL KEY PROGRAMMING Turn the ignition switch to the ON position using key 3. Verify that the security light illuminates for approx. 3 s , and then turns off. Remove key 3. Are there other keys to be programmed?	Yes	Go back to Step 1.
2		No	Go to the next step.
3	VERIFY KEY PROGRAMMING IS CORRECT Verify that the engine can start and run for approx. 5 s or more using all the programmed keys. NOTE: When verifying that the engine starts, wait at least approx. 5 s or more before starting the engine using the next key.	Procedure is complete

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.