Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Door Lock Control Module Removal/Installation [With Advanced Keyless System
2011 Mazda 3 Mazdaspeed, 2.3 3SECTION Door Lock Control Module Removal/Installation [With Advanced Keyless System
WARNING: This page is about a different car, the 2011 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the negative battery cable.
- Remove the glove compartment. (See GLOVE COMPARTMENT REMOVAL/INSTALLATION .)
- Remove the bolts.
- Remove the connector clip installed to the bracket by shifting the door lock control module downward.
- Disconnect the keyless unit connector.
- Remove the nut, then remove the keyless receiver form the door lock control module.
- Install in the reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.