Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Combined Sensor Inspection
- Turn the ignition switch off.
- Connect the M-MDS to the DLC-2.
- Select the following PIDs, then inspect the lateral acceleration speed and the yaw rate.
- LAT_ACCL: (lateral acceleration speed)
- YAW_RATE: (yaw rate)
- Lateral acceleration speed inspection
- Verify the LAT_ACCL change when the combined sensor is tilted to the left and right.
- If there is any malfunction, replace the combined sensor.
Standard
When the sensor is tilted to the right:
LAT_ACCL changes negatively.
When the sensor is tilted to the left:
LAT_ACCL changes positively.
- Verify the LAT_ACCL change when the combined sensor is tilted to the left and right.
- Yaw rate inspection
- Verify the YAW_RATE change when the combined sensor is rotated to the left and right.
- If there is any malfunction, replace the combined sensor.
Standard
When the sensor is rotated to the right:
YAW_RATE changes negatively.
When the sensor is rotated to the left:
YAW_RATE changes positively.
- Verify the YAW_RATE change when the combined sensor is rotated to the left and right.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.