Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20113 MAZDASPEED, 2.3 3REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 629 (ENGINE CONTROL SYSTEM)THROTTLE POSITION (TP) SENSOR INSPECTIONCIRCUIT OPEN/SHORT INSPECTION
2011 Mazda 3 Mazdaspeed, 2.3 3
Circuit Open/Short Inspection
2011 Mazda 3 Mazdaspeed, 2.3 3SECTION Circuit Open/Short Inspection
WARNING: This page is about a different car, the 2011 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the PCM connector.
- Disconnect the throttle body connector.
- Inspect the following wiring harnesses for open or short circuit. (Continuity inspection)
Open circuit
- If there is no continuity in the following wiring harnesses, there is an open circuit. Repair or replace the wiring harness.
- Throttle body terminal C and PCM terminal 2P
- Throttle body terminal D and PCM terminal 2AL
- Throttle body terminal E and PCM terminal 2AO
- Throttle body terminal F and PCM terminal 2AK
Short circuit
- If there is continuity in the following wiring harnesses, there is a short circuit. Repair or replace the wiring harness.
- Throttle body terminal E and body ground
- Throttle body terminal E and power supply
- Throttle body terminal F and body ground
- Throttle body terminal F and power supply
- Throttle body terminal D and body ground
- Throttle body terminal D and power supply
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.