Continuity Inspection

2011 Mazda 3 Mazdaspeed, 2.3 3SECTION Continuity Inspection
WARNING: This page is about a different car, the 2011 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [13B-MSP] .)
  2. Disconnect the negative battery cable.
  3. Remove the neutral switch. (See NEUTRAL SWITCH REMOVAL/INSTALLATION .)
  4. Verify that the continuity between neutral switch terminals A and B is as indicated in the table.
Fig 1: Inspecting Neutral Switch
G05981122Courtesy of MAZDA MOTORS CORP.
CONTINUITY REFERENCE CHART

Measurement condition Continuity
Push the rod No continuity
Except above Continuity detected
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.