Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20113 MAZDASPEED, 2.3 3REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 62 (ENGINE CONTROLS [SYSTEM & COMPONENT TESTING])FUEL SYSTEMFUEL CONTROLFUEL INJECTOR VOLUME
2011 Mazda 3 Mazdaspeed, 2.3 3
Fuel Injector Volume
2011 Mazda 3 Mazdaspeed, 2.3 3SECTION Fuel Injector Volume
WARNING: This page is about a different car, the 2003 Mazda Protege5, 2003 Mazda Protege, 2003 Mazda MX-5 Miata, 2003 Mazda MPV, and 2003 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect battery. Remove fuel rail assembly and fuel injectors from intake manifold. See REMOVAL, OVERHAUL & INSTALLATION article.
- Using a fused jumper wire, connect DLC-1 connector terminals F/P and GND. Connect aftermarket fuel injector tester to fuel injector. Turn ignition on for 15 seconds. Measure each fuel injector output volume. See FUEL INJECTOR OUTPUT VOLUME SPECIFICATIONS table. If fuel injector output volume is not as specified, replace fuel injector.
- When all fuel injectors have been checked, remove fuel injector tester and reinstall all components. Check system for leaks.
FUEL INJECTOR OUTPUT VOLUME SPECIFICATIONS
| Application | Quantity (cc) |
|---|---|
| MAZDA6 (2.3L) | 61-79 |
| Miata | 68-82 |
| MAZDA6 (3.0L) & MPV | 49-65 |
| Protege & Protege5 | 68-75 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.