SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20113 MAZDASPEED, 2.3 3REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 308 (SECURITY SYSTEM AND LOCKS SYSTEM)LIFTGATE WINDOW LATCHINSTALLATION
2011 Mazda 3 Mazdaspeed, 2.3 3

Liftgate Window Latch: Installation

2011 Mazda 3 Mazdaspeed, 2.3 3SECTION Installation
WARNING: This page is about a different car, the 2003 Mazda Tribute. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Positioning Liftgate Window Latch
G01903976Courtesy of MAZDA MOTORS CORP.
  1. Position the liftgate window latch and loosely install the bolts.
  2. Adjust the liftgate window latch.
    1. Set the liftgate window glass flushness to 1.5 mm (0.06 in) under flush.
      Fig 2: Tightening Liftgate Window Latch Bolts
      G01903977Courtesy of MAZDA MOTORS CORP.
  3. Tighten the liftgate window latch bolts.
    Fig 3: Connecting Liftgate Window Latch
    G01903978Courtesy of MAZDA MOTORS CORP.
  4. Connect the liftgate window latch.
    1. Connect the liftgate window latch ajar switch electrical connector.
    2. Connect the actuating rod and close the clip.
  5. Install the liftgate trim panel.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.