Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20113 MAZDASPEED, 2.3 3REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 275 (BASIC SYSTEM (HVAC))A/C COMPRESSOR REMOVAL/INSTALLATIONA/C COMPRESSOR INSTALLATION NOTE
2011 Mazda 3 Mazdaspeed, 2.3 3
A/C Compressor Installation Note
2011 Mazda 3 Mazdaspeed, 2.3 3SECTION A/C Compressor Installation Note
WARNING: This page is about a different car, the 2003 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the following amount of compressor oil from the new A/C compressor when replacing the A/C compressor.
Compressor oil to be removed (approximate quantity)
- 150 ml {150 cc, 5.07 fl oz} - [compressor oil from old A/C compressor + 15 ml {15 cc, 0.5 fl oz}]
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.