Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20113 MAZDASPEED, 2.3 3REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 210 (LIGHTING SYSTEM)REAR COMBINATION LIGHT REMOVAL/INSTALLATIONNOTES
2011 Mazda 3 Mazdaspeed, 2.3 3
Rear Combination Light Removal/Installation: Notes
2011 Mazda 3 Mazdaspeed, 2.3 3SECTION Notes
WARNING: This page is about a different car, the 2004 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the negative battery cable.
- Remove the rear side trim. (Right side only.) (See REAR SIDE TRIM REMOVAL/INSTALLATION .)
- Remove in the order indicated in the table/figure.REMOVING/INSTALLING REAR COMBINATION LIGHT (1)
Component/Step No. Component Description 1 Connector 2 Screw 3 Rear Combination Light (See REAR COMBINATION LIGHT REMOVAL NOTE ) 4 Socket (See SOCKET INSTALLATION NOTE ) 5 Brake Light/Taillight Bulb 6 Rear Turn Light Bulb 7 Back-up Light Bulb 8 Taillight Bulb (1) See Fig 1. - Install in the reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.