Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSMAZDA20113 MAZDASPEED, 2.3 3REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 210 (LIGHTING SYSTEM)PANEL LIGHT CONTROL SWITCH REMOVAL/INSTALLATIONNOTES

2011 Mazda 3 Mazdaspeed, 2.3 3

Panel Light Control Switch Removal/Installation: Notes

2011 Mazda 3 Mazdaspeed, 2.3 3SECTION Notes

WARNING: This page is about a different car, the 2004 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the negative battery cable.
Remove the driver-side side panel.

Remove in the order indicated in the table/figure.

REMOVING/INSTALLING PANEL LIGHT CONTROL SWITCH ⁽¹⁾

Component/Step No.

Component Description

Panel light control switch (See PANEL LIGHT CONTROL SWITCH REMOVAL NOTE )

Connector

⁽¹⁾	See Fig 1.

Fig 1: Removing/Installing Panel Light Control Switch

Courtesy of MAZDA MOTORS CORP.

Install in the reverse order of removal.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.