Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20113 MAZDASPEED, 2.3 3REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 193 (ENGINE CONTROL SYSTEM)ENGINE COOLANT TEMPERATURE (ECT) SENSOR REMOVAL/INSTALLATION
2011 Mazda 3 Mazdaspeed, 2.3 3
Engine Coolant Temperature (ECT) Sensor Removal/Installation
2011 Mazda 3 Mazdaspeed, 2.3 3SECTION Engine Coolant Temperature (ECT) Sensor Removal/Installation
WARNING: This page is about a different car, the 2004 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
- Drain the engine coolant. (See COOLING SYSTEM SERVICE WARNINGS .) (See ENGINE COOLANT REPLACEMENT .)
- Disconnect the ECT sensor connector.WARNING:
- When the engine is hot, it can badly burn. Turn off the engine and wait until it is cool before removing the ECT sensor.
- Remove the ECT sensor.
- Replace the gasket.
- Install in the reverse order of removal.
- Refill the engine coolant. (See COOLING SYSTEM SERVICE WARNINGS .) (See ENGINE COOLANT REPLACEMENT .)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.