SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20113 MAZDASPEED, 2.3 3REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 102 (GENERATORS & REGULATORS)GENERATOR SPECIFICATIONS2004
2011 Mazda 3 Mazdaspeed, 2.3 3

Generator Specifications: 2004

2011 Mazda 3 Mazdaspeed, 2.3 3SECTION 2004
WARNING: This page is about a different car, the 2004 Mazda 6 and 2003 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
GENERATOR SPECIFICATIONS

Application Specification
Brush Length
Standard
2.3L 0.73" (18.5 mm)
3.0L 0.89" (22.5 mm)
Minmum (All) 0.20" (5.0 mm)
Brush Spring Force
Standard
2.3L 1.08-1.35 lb.f (4.8-6.0 N)
3.0L 0.92-1.19 lb.f (4.1-5.3 N)
Minimum
2.3L 0.49 lb.f (2.2 N)
3.0L 0.38 lb.f (1.7 N)
Generator Output
2.3L 90 Amps
3.0L 110 Amps
Rotor Resistance (Between Slip Rings)
2.3L (1) 1.6-2.0 Ohms
3.0L (1) 2.4-2.9 Ohms
(1) At 68°F (20°C).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.