SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20113 MAZDASPEED, 2.3 3REPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSON-BOARD DIAGNOSTIC [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM]DTC INSPECTION [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM]
2011 Mazda 3 Mazdaspeed, 2.3 3

DTC Inspection [Advanced Keyless Entry And Push Button Start System]

2011 Mazda 3 Mazdaspeed, 2.3 3SECTION DTC Inspection [Advanced Keyless Entry And Push Button Start System]
  1. Connect the M-MDS to the DLC-2.
  2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS.
    • When using the IDS (laptop PC)
      1. Select "Self Test".
      2. Select "Modules".
      3. Select "RKE".
    • When using the PDS (Pocket PC)
      1. Select "Module Tests".
      2. Select "RKE".
      3. Select "Self Test".
  3. Verify the DTC according to the directions on the screen.
    Fig 1: Identifying DLC-2
    G06734053Courtesy of MAZDA MOTORS CORP.
    • If any DTCs are displayed, perform troubleshooting according to the corresponding DTC inspection.
  4. After completion of repairs, clear all DTCs stored in the keyless control module. (See CLEARING DTC [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM] ).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.