SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20113 MAZDASPEED, 2.3 3REPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTIGNITION SWITCH/STEERING LOCKPOWER SYSTEMSPUSH BUTTON START REMOVAL/INSTALLATION [WITH ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM]
2011 Mazda 3 Mazdaspeed, 2.3 3

Push Button Start Removal/Installation [With Advanced Keyless Entry And Push Button Start System]

2011 Mazda 3 Mazdaspeed, 2.3 3SECTION Push Button Start Removal/Installation [With Advanced Keyless Entry And Push Button Start System]
  1. Disconnect the negative battery cable.
  2. Remove the following parts:
    1. Front scuff plate (Driver side) (See FRONT SCUFF PLATE REMOVAL/INSTALLATION ).
    2. Front side trim (Driver side) (See FRONT SIDE TRIM REMOVAL/INSTALLATION ).
    3. Upper panel (See UPPER PANEL REMOVAL/INSTALLATION ).
    4. Shift knob (MTX) (See MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION ).
    5. Selector lever knob (ATX) (See AUTOMATIC TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION ).
    6. Shift panel (See SHIFT PANEL REMOVAL/INSTALLATION ).
    7. Side wall (See SIDE WALL REMOVAL/INSTALLATION ).
    8. Console (See CONSOLE REMOVAL/INSTALLATION ).
  3. Set the hood release lever out of the way. (See HOOD LATCH AND RELEASE LEVER REMOVAL/INSTALLATION ).
  4. Partially peel back the seaming welt.
  5. Remove the lower panel. (See LOWER PANEL REMOVAL/INSTALLATION ).
  6. Release the tabs and remove the push button start from the lower panel.
  7. Install in the reverse order of removal.
    Fig 1: Removing Push Button Start From Lower Panel
    G06733174Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.