Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2010TRIBUTE HYBRID GRAND TOURING, AWDREPAIR AND DIAGNOSISENGINE PERFORMANCEENGINE CONTROL SYSTEMSMASS AIR FLOW (MAF) SENSOR REMOVAL/INSTALLATION - 2.5L
2010 Mazda Tribute Hybrid Grand Touring, AWD
Mass Air Flow (MAF) Sensor Removal/Installation - 2.5L
2010 Mazda Tribute Hybrid Grand Touring, AWDSECTION Mass Air Flow (MAF) Sensor Removal/Installation - 2.5L
- Disconnect the mass air flow (MAF) sensor electrical connector.
- Remove the 2 screws and the MAF sensor.
- To install, tighten to 10 N.m {1.0 kgf.m, 89 in.lbf}.
- To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.