Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2010CX-7 AWD L4-2.3L TURBOREPAIR AND DIAGNOSISWIPER AND WASHER SYSTEMSTESTING AND INSPECTION
2010 Mazda CX-7 AWD L4-2.3L Turbo
Wiper and Washer Systems: Testing and Inspection
2010 Mazda CX-7 AWD L4-2.3L TurboSECTION Testing and Inspection
DTC INSPECTION [AUTO LIGHT/WIPER CONTROL MODULE]
1. Connect the M-MDS to the DLC-2.
2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS.
- When using the IDS (laptop PC)
1 Select "Self Test".
2 Select "Modules".
3 Select "LCM".
- When using the PDS (Pocket PC)
1 Select "Module Tests".
2 Select "LCM".
3 Select "Self Test".
3. Verify the DTC according to the directions on the screen.
- If any DTCs are displayed, perform troubleshooting according to the corresponding DTC inspection.
4. After completion of repairs, clear all DTCs stored in the auto light/wiper control module. Clearing DTC - Auto Light/Wiper Control Module
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.