Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20105 SPORT, 2.3 L, STANDARDREPAIR AND DIAGNOSISGENERAL INFORMATIONOBD-II DRIVE CYCLESDRIVE CYCLES2012-13: MAZDA5MODE 06 (EVAP SYSTEM REPAIR VERIFICATION DRIVE MODE)
2010 Mazda 5 Sport, 2.3 L, Standard
Mode 06 (EVAP System Repair Verification Drive Mode)
2010 Mazda 5 Sport, 2.3 L, StandardSECTION Mode 06 (EVAP System Repair Verification Drive Mode)
NOTE:
If "EVAP System Repair Verification Drive Mode" cannot be performed (it is impossible to drive the vehicle under this Drive Mode condition), perform evaporative system test procedure as an alternative. (See ENGINE CONTROL SYSTEM OPERATION INSPECTION [MZR 2.5].)
- Verify that all of the following PIDs are within the following specifications. All PIDs must be within specifications before engine is started to initiate the evaporative system test.
- IAT:5-35 °C {41-95 °F}
- FLI:15-85%
- BARO:72.2 kPa {542 mmHg, 21.3 inHg} or higher
- Start the engine and warm it up completely.
- Clear the DTC from the PCM memory using the M-MDS.
- Drive the vehicle as shown in the graph in illustration.
- Access the ON BOARD SYSTEM READINESS to verify the OBD monitoring status.
- If completed, the OBD monitoring status items change from non-completed to completed.
- If not completed, switch the ignition to off then go back to Step 1.
- Access the DIAGNOSTIC MONITORING TEST RESULTS to verify the monitor results.
- If detected values are not within specification, repair has not completed.
- Verify no DTCs are available.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.