SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20105 SPORT, 2.3 L, STANDARDREPAIR AND DIAGNOSISGENERAL INFORMATIONOBD-II DRIVE CYCLESDRIVE CYCLES2004: MPVMODE 2 (EGR SYSTEM REPAIR VERIFICATION DRIVE MODE)
2010 Mazda 5 Sport, 2.3 L, Standard

Mode 2 (EGR System Repair Verification Drive Mode)

2010 Mazda 5 Sport, 2.3 L, StandardSECTION Mode 2 (EGR System Repair Verification Drive Mode)
  1. Perform "PCM Adaptive Memory Produce Drive Mode" first.
  2. Verify that all accessory loads (A/C, headlights, blower fan, rear window defroster) are off.
  3. Drive the vehicle as shown in the graph.
  4. Stop the vehicle and access the ON BOARD SYSTEM READINESS menu of GENERIC OBD II FUNCTION to verify the OBD monitoring status.
    • If completed, the OBD monitoring status items change from non-completed to completed.
    • If not completed, turn the ignition key off then repeat from Step 2.
  5. Access DIAGNOSTIC MONITORING TEST RESULTS menu of GENERIC OBD II FUNCTIONS to verify the monitor results.
    • If detected values are not within specification, repair has not been completed.
  6. Verify no DTCs are available.
    Fig 1: Vehicle Drive Graph (Mode 2)
    G00992219Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.