SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20105 SPORT, 2.3 L, STANDARDREPAIR AND DIAGNOSISGENERAL INFORMATIONOBD-II DRIVE CYCLESDRIVE CYCLES2002-03: MX-5 MIATAMODE 2 - EGR SYSTEM REPAIR VERIFICATION DRIVE MODE
2010 Mazda 5 Sport, 2.3 L, Standard

Mode 2 - EGR System Repair Verification Drive Mode

2010 Mazda 5 Sport, 2.3 L, StandardSECTION Mode 2 - EGR System Repair Verification Drive Mode
  1. Perform Drive Mode 1 first.
  2. Verify all accessory loads (A/C, headlights, blower fan, rear window defroster) are off.
  3. Ensure engine at normal operating temperature and drive vehicle as shown in the graph. SeeFig 1.
  4. Stop vehicle and access ON BOARD SYSTEM READINESS menu of GENERIC OBD-II FUNCTIONS to inspect Drive Mode completion status.
    • If completed, RFC change from NO to YES.
    • If not completed, turn ignition key off and repeat test from step 3).
  5. Access DIAGNOSTIC MONITORING TEST RESULTS menu of GENERIC OBD-II FUNCTIONS to inspect monitor results:
    • If MEAS are within specification, repair is completed.
    • If MEAS are not within specification, repair is not completed.
  6. Verify no DTCs are available.
Fig 1: EGR System Repair Verification Drive Mode, Vehicle Speed Table
G00162127Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.